|
Hemostatic agents based on ferric sulfate or aluminum chloride - and even the powder in your latex gloves - all contain sulfur. Sulfur contamination is one of the primary reasons your impression material won't set, has voids, or has air bubbles. Additionally, organic debris often gets picked up in your impression, causing innacuracies. These clinical challenges can force you into multiple retakes of the impression.
Another common cause of an imprefect impression is uncured methacrylate (from your temporary material) left on the prep site. You may think your air/water syringe cleans the prep site adequately, but it often does not.
These kinds of chemical interferences occur more often than any dentist is willing to admit, and unfortunately, the blame is often placed on the impression material when things go wrong.
DETAIL - Pre-Impression
Cleansing Gel guarantees a clean, decontaminated prep site and consequently, an accurate impression every time. In just 10 seconds, DETAIL will lift organic debris and contaminants such as sulfur and methacrylate residue from your prep site. Rinse away DETAIL, and the impression surface left behind will be squeaky-clean (figs 1, 2 below).
A clean preparation give you a more accurate impression; however, DETAIL does more than just clean the prep site. DETAIL also alters the surface tension of the preparation so your impression material contacts the surface more intimately. The result? The most detailed and accurate impression possible.
Consider DETAIL your insurance policy against surface contaminates and your guarantee of a perfect impression.
|
|
|
|
Freshly cut preparation (smear layer) containing
blood, hemostatic agent, and possibly headpiece oil. All of
which can prevent a properly cured and accurate impression.
|
|
In just 0:15 seconds, DETAIL removes the
contaminated surface, while leaving the dentin tubule plugs
in place, and allowing for a cleaner, decontaminated prep
site. |
Clinical Technique - Cleaning the Preparation
-
Syringe Detail Pre-Impression Cleansing Gel around the sulcus and entire tooth preparation (fig 1). (Or, if desired, apply Detail with a Multi-Brush Dental Applicator).
-
Wait 10 seconds.
-
Rinse with copious amounts of water in conjunction with suction (3-5 seconds or until Detail is completely removed from the preparation site).
-
Using an air syringe, ensure that the tooth preparation is air dried prior to proceeding with impression technique.
-
Detail leaves behind not only a clean preparation (fig 2) , but also a hydroactive surface - both will yield the cleanest, most detailed impression you've ever seen!
For an even better and more efficient impression procedure, use DETAIL in conjunction with 3rd Generation AFFINITY Hydroactive Impression Material.
 |
Pre-Impression Cleansing Gel guarantees a clean, decontaminated prep site and consequently, an accurate impression every time. In just 10 seconds, DETAIL will lift organic debris and contaminants such as sulfur and methacrylate residue from your prep site
(4) 3 mL syringes, (50) 22 gauge needle tips, (20) multi-brush samples,
instructions, MSDS
|
|
|
|
|
|
|
